284e low density, washed out images.

[Dustp115]

Evening all.

Im having some issues with a 284e, that I cant seem to resolve.

Apparently this machine has been doing this for quite some time, I was there for another issue and this was brought up.
The prints are very light, I cranked up the min density adjustment to 10 and it did not have much effect , also I am unable to perform image stabilization as it comes up NG right after I hit start so no graduation adjustment either. Transfer belt is new and drums look ok, slit glass is clean. Does anyone have any suggestions?

Thanks



I attached a printed chart but the scan does not really show just how washed out it actually is.

[copyman]

Re: 284e low density, washed out images.

Check the developer units. you will prob find one of them has hardly any developer on mag roller. this is becoming very common on these machines. happens most of the time from going over the life of drums, etc.