Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

[Cantechman]

Re: Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

Hi,
Bizhub C452 after fusing repair doesn't print even Demo or configuration page. After sending print command from Network PC, Data light just blinking and after that it's not possible to cancel or check Job details for deleting.In fact there is any job in Job history. it has to be switched off and on again for checking utility or other menu. checking other post in this regard, following jobs are done:

1-check from panel that user authentication/account track is off.
2-The same from driver properties,configuration tab and both user/account authentication is off.
3-Initialize from service mode and clear all data(not errors).
4-there is no ip conflict and drivers are reinstalled.
5-Network setting reset
and there is no error code!
I just tried to format the HDD but from Admin panel->Security the HDD setting is missed out!

I know this occurred for many Techs but I didn't find any clear reason & solution.
Any idea and recommendation would be great.

Try just unplugging the network cable and them turning the machine on and then try internal prints it will at least rule out your network.

[Terna247]

Re: Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

'I just tried to format the HDD but from Admin panel->Security the HDD setting is missed out!'

Pluck out the NVram
Put on the machine
It will display a message about serial number
Put it off again, hang back the ram and on again
Best of luck.

[mjunkaged]

Re: Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

I agree with Allan, UNSET the HDD, do not remove NVRAM unless you want your (mostly working) copier to NOT work at all. OR have more problems to deal with!
Service mode, trouble isolation. GOOD LUCK!

[mjunkaged]

Re: Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

I agree with Allan, UNSET the HDD, do not remove NVRAM unless you want your (mostly working) copier to NOT work at all. OR have more problems to deal with!
Service mode, trouble isolation. GOOD LUCK!

........Or was that 'set' to turn it off? I think default is unset? It's been a LOOOOOONNNNGG week for me copy-wise! Whichever one it's NOT when you look at it (HDD) under trouble isolation!

[lazymangr]

Re: Bizhub C452 doesn't p-rint after Fusing repair,data light blinking,no Demo p-rint

if the hdd format from admin menu is missing that means the hdd is unset. do the format from service mode and also check if its installed in service mode