Bizhub C35 print problem

[Konicatech]

98BD2EF8-63BA-40CE-9D2A-EDB20613B40A.jpg

[Phil B.]

Re: Bizhub C35 print problem

[ATTACH=CONFIG]41668[/ATTACH]

Page count on parts?
whats been done?

looks like belt or Drum

[allan]

Re: Bizhub C35 print problem

Pull out the one of the image units and gently pull the toner roller away from the drum.
There you will find an in your case a massive buildup of toner on top of the doctor blade.
Take is outside and blow it out with a blower brush or syringe bulb.
It my experience you will ultimately need to replace the units.

Have they been reset? Or rather more than once?
Using original toner?

[Konicatech]

Re: Bizhub C35 print problem

Done that but no build up of toner, cleaned anyway. Still the same

Thinking belt?

[Konicatech]

Re: Bizhub C35 print problem

Belt looks like this 421661BC-5D67-4FBF-8F82-40B2B6FED740.jpg

[Toxic]

Re: Bizhub C35 print problem

I have this few times on c25 and c35.
Always was problem temperature difference in room and toner and developer inside IU get moisture, this only happened in winter and autumn rainy days, never during summer.
1 machine was in room where over night temperature goes under 0 celsius and you can imagine what is scenario when they turn on machine on the morning and fuser get at almost 200 celsius in a minute.
Partly solved by not turning off machine during night and replacing imaging units.

[Phil B.]

Re: Bizhub C35 print problem

Belt looks like this [ATTACH=CONFIG]41669[/ATTACH]

Belt cleaning blade has failed. replace it unless belt is very worn then replace whole assmy

[allan]

Re: Bizhub C35 print problem

Done that but no build up of toner, cleaned anyway. Still the same

Thinking belt?

Original toner?
Units been reset?