Job Settings Timeout limit BH C451 and up?

[Synaux]

I swear there was a setting to extend the job-settings timeout...

Explanation:
Let's say you change any setting in a copy job: half-fold/tri-fold/duplex/staple/etc it reverts to default job settings after a short time (scans too but obviously different settings).

I was certain there was a setting to extend this; however, on a handful of models in these series (c45xx), I went through all the user/admin/SM settings a few times over and did not see anything relevant.

So yeah... Am I crazy or....

Thanks

[907tec]

Re: Job Settings Timeout limit BH C451 and up?

Have you checked Admin / System / Reset Settings? If you have the User Guide Copy Operations, it's in section 11-38 / p.699.

[Synaux]

Re: Job Settings Timeout limit BH C451 and up?

Have you checked Admin / System / Reset Settings? If you have the User Guide Copy Operations, it's in section 11-38 / p.699.

Oh boy...I read that as something totally different.
I knew it was going to be something so simple I almost didn't even want to ask the question.

Thanks man, I was beginning to think I was losing my mind!

[907tec]

Re: Job Settings Timeout limit BH C451 and up?

No prob, happy to help.

[Woxner]

Re: Job Settings Timeout limit BH C451 and up?

i think what you are after is accessabillity tab. panel setting are there