bizhub C364e with FA14 C-4091

[tsbservice]

Re: bizhub C364e with FA14 C-4091

Hi, now I have replaced the monitor from another machine and it seems to work. However, the problem does not occur in the other machine.


However now I have a new problem. With the new SSD and MFPB, the CE Password and Admin password do not work.

Regarding CE Password. Generate request code and send it to KM, they should verify it and give you another to put into the machine, from there you can change Admin pass.

Regarding panel assembly. Change A5C1N15601 Interface Cable.

[Bix]

Re: bizhub C364e with FA14 C-4091

Thank you! However, a short while ago the other machine also crashed the display so I think it's defective.


Now I will try to put back the old motherboard and SSD. I'll keep you up-to-date

[CompyTech]

Re: bizhub C364e with FA14 C-4091

Hopefully you didn't replace the SSD and the MFPB at the same time.

[Bix]

Re: bizhub C364e with FA14 C-4091

No, I didn't. But since the monitor did not work, in the FW installation it started automatically with a wrong Machine Type. Perhaps that caused problems.


However now I put the old MFPB and the old SSD and it all works again.


In summary: the problem was the panel. By replacing the entire screen the problem is solved.

[danetime]

Re: bizhub C364e with FA14 C-4091

Having the same issue with Km 458 and 308 all in the same location. Have tried everything with no success.
Did changing the ops panel finally cure the problem?

[besto konica]

Re: bizhub C364e with FA14 C-4091

Fa14 is problem in memory
MFPB
You need change it

[Phil B.]

Re: bizhub C364e with FA14 C-4091

Having the same issue with Km 458 and 308 all in the same location. Have tried everything with no success.
Did changing the ops panel finally cure the problem?

"In summary: the problem was the panel. By replacing the entire screen the problem is solved."

the very last line in his post.

[Bix]

Re: bizhub C364e with FA14 C-4091

Two cases in the same place are ambiguous.


Make sure there are no network problems. In my case it was the screen panel but that mistake is pretty general.