Kyocera guy here with a Minolta question

[Scott]

I have a C452 needing a transfer belt 1st does anyone have one for sale??? 2nd would a 654e work?? "asking for a friend" LOL

[djs9164]

Re: Kyocera guy here with a Minolta question

Need the specific belt. Usually available through Precision/ Etc.

Sent from my XT1635-01 using Tapatalk

[djs9164]

Re: Kyocera guy here with a Minolta question

Need the specific belt. Usually available through Precision/ Etc.

Sent from my XT1635-01 using Tapatalk

My bad. Just checked prcesion roller. Expensive, but same belt.

Sent from my XT1635-01 using Tapatalk

[Scott]

Re: Kyocera guy here with a Minolta question

Is it a tuffy to install the belt on the assembly??

[djs9164]

Re: Kyocera guy here with a Minolta question

Only comes as an assembly . Wouldn't even try to trace the belt.

Sent from my XT1635-01 using Tapatalk

[Scott]

Re: Kyocera guy here with a Minolta question

Ya that is what I am seeing only buy as a assembly, however I am seeing belt for the assembly for sale and not sure I was wanting to tackle that

[Synthohol]

Re: Kyocera guy here with a Minolta question

not worth rebuilding, too easy to ding the belt or crack it.
they are good for 600k+ you will make it back on clicks.