Bizhub C224e not detecting firmware

Collapse
X
Collapse
 
  • Page of 3
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
  • copier tech
    replied
    Re: Bizhub C224e not detecting firmware

    Originally posted by Ari007
    I have a bizhub c224e, with low copy/print. The machine was running fine but had some deep sleep issues. Now, if the main sw is turned on it does the full warmup procedure(can tell from the sound) and gets stuck at two fins. If firmware is inserted from service port first it stays off and if main switch is turned on/off it again gets stuck at two fins.

    *SSD replaced
    *All the sensors are working
    *HDD is disconnected and disabled from service mode.

    Please help.
    How did you enter CE mode to disable the HDD if the machine wont boot?

      Leave a comment:

    • Ari007
      replied
      Re: Bizhub C224e not detecting firmware

      Originally posted by tsbservice
      Turn on machine while holding op panel's Power button, wait for a beep. Do self diagnostic and look for any NG results, probably if it fails at second pillar(fin) some memory tests will fail.
      I've already ordered replacement RAM.. hopefully will get it within two days.. I'll try this

        Leave a comment:

      • tsbservice
        replied
        Re: Bizhub C224e not detecting firmware

        Turn on machine while holding op panel's Power button, wait for a beep. Do self diagnostic and look for any NG results, probably if it fails at second pillar(fin) some memory tests will fail.

          Leave a comment:

        • Ari007
          replied
          Re: Bizhub C224e not detecting firmware

          Originally posted by Phil B.
          sounds like you need a service manual
          I already have.. and went through the procedures.. this is an uncommon problem..

            Leave a comment:

          • Phil B.
            replied
            Re: Bizhub C224e not detecting firmware

            Originally posted by Ari007
            I have a bizhub c224e, with low copy/print. The machine was running fine but had some deep sleep issues. Now, if the main sw is turned on it does the full warmup procedure(can tell from the sound) and gets stuck at two fins. If firmware is inserted from service port first it stays off and if main switch is turned on/off it again gets stuck at two fins.

            *SSD replaced
            *All the sensors are working
            *HDD is disconnected and disabled from service mode.

            Please help.
            sounds like you need a service manual

              Leave a comment:

            • Ari007
              started a topic [Misc] Bizhub C224e not detecting firmware

              Bizhub C224e not detecting firmware

              I have a bizhub c224e, with low copy/print. The machine was running fine but had some deep sleep issues. Now, if the main sw is turned on it does the full warmup procedure(can tell from the sound) and gets stuck at two fins. If firmware is inserted from service port first it stays off and if main switch is turned on/off it again gets stuck at two fins.

              *SSD replaced
              *All the sensors are working
              *HDD is disconnected and disabled from service mode.

              Please help.
              Tags: c224e, fins, main, service, turned
              Previous 1 2 3 template Next
              Working...