66-01 df628 bizhub 227

[Bix]

Re: 66-01 df628 bizhub 227

I happened to find cracker crumbs inside the rollers often. Someone likes to eat before scanning

[Bix]

Re: 66-01 df628 bizhub 227

Hi guys, I'm looking at these bizhub 227s
Many of them cause me jam (66-33, 66-04, 66-05 etc.)
Usually I solve by cleaning the sensors, but the problem sometimes returns after 2-3 months.

In the manual it says that the ADF rollers last about 200k. I looked at the ADF roller counters and I often read only 40k-50k. Visually it looks already worn out. Any experience on these rollers? Do you think they are the sensors or maybe the rollers don't last as they should?
These printers are in normal offices. The paper doesn't look bad either. In fact, there are no jams from the trayers for now.

[robinsonad86]

Re: 66-01 df628 bizhub 227

Hi guys, I'm looking at these bizhub 227s
Many of them cause me jam (66-33, 66-04, 66-05 etc.)
Usually I solve by cleaning the sensors, but the problem sometimes returns after 2-3 months.

In the manual it says that the ADF rollers last about 200k. I looked at the ADF roller counters and I often read only 40k-50k. Visually it looks already worn out. Any experience on these rollers? Do you think they are the sensors or maybe the rollers don't last as they should?
These printers are in normal offices. The paper doesn't look bad either. In fact, there are no jams from the trayers for now.

Konica rollers never do anywhere near the listed life

[blinxwap]

Re: 66-01 df628 bizhub 227

Hi guys, I'm looking at these bizhub 227s
Many of them cause me jam (66-33, 66-04, 66-05 etc.)
Usually I solve by cleaning the sensors, but the problem sometimes returns after 2-3 months.

In the manual it says that the ADF rollers last about 200k. I looked at the ADF roller counters and I often read only 40k-50k. Visually it looks already worn out. Any experience on these rollers? Do you think they are the sensors or maybe the rollers don't last as they should?
These printers are in normal offices. The paper doesn't look bad either. In fact, there are no jams from the trayers for now.

I usually put of the feed roller and take a a00j...... feed roller and pull it over the original adf roller holder or try loop adjustment 1mm for each side

Sent from my SM-A505F using Tapatalk

[Bix]

Re: 66-01 df628 bizhub 227

It has never been clear to me where that white piece fits. Exactly where should it be put to increase pressure?
Thank you!

[tsbservice]

Re: 66-01 df628 bizhub 227

I usually put of the feed roller and take a a00j...... feed roller and pull it over the original adf roller holder or try loop adjustment 1mm for each side

Sent from my SM-A505F using Tapatalk

It has never been clear to me where that white piece fits. Exactly where should it be put to increase pressure?
Thank you!

I think blinxwap means just to replace original feed roller with A00J563600 not to use white spacer.