J-3203 Bizhub PRO 950

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • escalante
    Trusted Tech

    100+ Posts
    • Sep 2018
    • 115

    J-3203 Bizhub PRO 950

    In the manual it tells me that it is a PS57 sensor. Which is marked with a red circle. Replace it with the PS57 sensor. I was not successful, I still had the same fault, then I replaced the PS8 sensor, not having much success I still had the fault. Any ideas, any suggestions are welcome.IMG-20201115-WA0000.jpg

    Enviado desde mi Infinix X656 mediante Tapatalk
  • Leyahné
    Technician
    • Feb 2016
    • 44

    #2
    Re: J-3203 Bizhub PRO 950

    Please check the ICP on the ADU board.

    Sent from my SM-N960F using Tapatalk

    Comment

    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22705

      #3
      Re: J-3203 Bizhub PRO 950

      What's up with that belt tensioner? Did you wrap in in tape to attempt to tighten the belt?

      The few times that I've seen 3203 jams it was caused by a damaged fuser claw.
      =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

      Comment

      • escalante
        Trusted Tech

        100+ Posts
        • Sep 2018
        • 115

        #4
        Re: J-3203 Bizhub PRO 950

        Goodnight. Thank you for your comment and suggestion.
        Tell him to fix the paper jam code fault by replacing the M5 motor part code: 56AA 8011 2

        Shown in the following pictureIMG-20201118-WA0032.jpg

        Enviado desde mi Infinix X656 mediante Tapatalk

        Comment

        Working...