Will not feed from any cassette, but will feed from the bypass. M1 drive motor runs good, did load test. On prcb board, cn 203 6a only get 5 vdc, should be 24. Get 24 on two other connectors on the board, so it is not the power source. When I do the load test for the clutches, I do not hear them engage. I felt some of the feed clutches, they were not hot. Tried a different prcb board, same problem. Anyone out there seen this??
-
Last edited by jej; 03-04-2009, 03:53 PM. -
Yes I have, it's sitting in our shop right now!
-
have you also checked the user settings on cassette eligibility? it can be offComment
-
The M1 motor was bad, killed the PRCB, wasn't getting 24 volts. Got a new board from Minolta, the board was bad, got a second board from Minolta and the new PRCB board fixed the problem.Comment
Comment