konica C360i

[KMFLT3CH]

Re: konica C360i

I have changed the CL 10 a C300i and the jams have disappeared but the message cleaning in progress is still on the screen a few times. I have updated the firmware but the warning keeps coming up.


Any idea how to make it not show up?


Thank you

Replace CL10 (AA2JM20100) and the tray 1 feed clutch CL3 (A7AHM20501) at the same time.

[avecosat]

Re: konica C360i

I have changed both, sorry. I no longer have jams but sporadically I get the cleaning in progress message and I don't know why

[Synthohol]

Re: konica C360i

just asking, have you checked the patches on the belt when it runs its self calibrations? if the patterns are not crisp or streaky it cant do a good AIDC or registration that could be the cleaning message and as a result if a paper was slightly advanced to get the waiting image but it cant pass its calibrations so the paper blocks the sensor as the machine goes into alert mode and codes.
or those weren't vitamin supplements this morning and im sleep-posting

i would check the transfer belt cleaning assy, they tend to clog and leave misted or used toner on the belt and it cant calibrate.

[avecosat]

Re: konica C360i

It is a machine installed only 20 days ago KM has no idea and the client does not want it now I have it in my office and after changing CL10 and CL3 it no longer gets jams but at the end of printing sometimes the cleaning in progress message appears I have tried with the k drum, today I will test the transfer unit thanks