Hello all,
Here is my info I have a KM 364e that will beep once on main power switch on then after a couple seconds cycle all copier Drive funtions with the first half tone screen in display. Then it dies driving and screen dies and beeps every 10 seconds or so. I have used the Manual and gone there. I disconnected the HDD to see if it would boot but no, I can feel it spinning. I put another Ram in no good.
I don't have a spare MFP PCB unit at the moment but I read on another forum where one man installed one but no luck either. I also read I could not put a used board in with the SDD thats in that unit also. Im in the process of getting a couple others for parts. I also know the process to order an sdd is complicated for a non dealer. Although if i get a used unit with its sdd in it then it sounds like I can put that in.
Here is a question someone may be able to help me with along with the above. the red D710 beside the chip does not light up and I saw on another unit the d708/d709/and d710 are lit when the machine comes to ready all red. I searched the manual as thorough as i could with search control F on. It will not find a D710 led indicator by the chip on the mfp board in the search and when i search the MFP i get over 1000 hits i tried to look though didn't see it if im blind let me know.
Let me know if you Konica Techs think In on the right track. Thanks All !!
Here is my info I have a KM 364e that will beep once on main power switch on then after a couple seconds cycle all copier Drive funtions with the first half tone screen in display. Then it dies driving and screen dies and beeps every 10 seconds or so. I have used the Manual and gone there. I disconnected the HDD to see if it would boot but no, I can feel it spinning. I put another Ram in no good.
I don't have a spare MFP PCB unit at the moment but I read on another forum where one man installed one but no luck either. I also read I could not put a used board in with the SDD thats in that unit also. Im in the process of getting a couple others for parts. I also know the process to order an sdd is complicated for a non dealer. Although if i get a used unit with its sdd in it then it sounds like I can put that in.
Here is a question someone may be able to help me with along with the above. the red D710 beside the chip does not light up and I saw on another unit the d708/d709/and d710 are lit when the machine comes to ready all red. I searched the manual as thorough as i could with search control F on. It will not find a D710 led indicator by the chip on the mfp board in the search and when i search the MFP i get over 1000 hits i tried to look though didn't see it if im blind let me know.
Let me know if you Konica Techs think In on the right track. Thanks All !!
.
Comment