femaster
-
Here is the relevant page from the troubleshooting guide. Since it never makes it to the data indicator turning on, your problem will be somewhere between... -
Wow, we have had hundreds of 4, 4e, 8 and 8e machines out in the field over the years (606 machines past and present to be exact), and to date have yet...Leave a comment:
-
The attached, recently released, Tech Bulletin from KM US sounds like it should answer some questions for those that are having problems.
...Leave a comment:
-
Since it's a 4e-series machine, try to boot into diagnostics. Hold down power button on control panel which turning on the main power switch. It will...Leave a comment:
-
I've seen that before. Cleaning blade in the drum is sticking to the drum surface when the drum jogs backwards ever so slightly after a job (to get the...Leave a comment:
-
I know this is quite the antique thread here, but I'm in the market for a new source of after market tires. We had a source from China, through AliExpress,...Last edited by femaster; 1 week ago.Leave a comment:
-
Did you remove the foam pads as was suggested? That is the cause most of the time....Leave a comment:
-
I haven't touch a machine like that in MANY years, but I think your best bet would be to cover the metal contacts that lead to the fuse with packing tape....Leave a comment:
-
Are you doing the calibration correctly? You'd be surprised at how many people do it wrong, thinking minimum and maximum are the guides all the way in...Leave a comment:
-
There really isn't much to check as far as that fan goes. Fan plugs into a very short harness that plugs directly into the MFPB.
...Leave a comment:
-
Neither of those exist on the US Konica firmware page. Perhaps only available through KM support?...Leave a comment:
-
You can use a new or used HDD. If you go the used route, you need to connect the drive to a PC and delete the partition table before installing it in...Leave a comment:
-
Remove the 4 sponge/foam noise dampening pads (and any remaining glue residue) that the exit unit gate touches. There are 2 behind the outer gate fins...Leave a comment:
No activity results to display
Leave a comment: