I have a C551i that has an issue with com10 envelopes. do the calibration on the bypass width sensors, calibrates ok. insert com10 envelope, it does not detect, set com10 manually and the machine generates an error that the guides are incorrect. I tied a new width sensor, no change in error. I have also tried a whole bypass assy., calibrates ok but i get the same error. i have also re-seated all wires and i don't see any bent pins on the connectors.
any suggestions would be appreciated. Im ready to resort to the BFH method of repair.
Thanks
any suggestions would be appreciated. Im ready to resort to the BFH method of repair.
Thanks
Comment