C250i No yellow on rear side of page

[tsbservice]

Re: C250i No yellow on rear side of page

I had an issue the other day when changing a drum.

When I released the pressure of the developer I lost magenta on the rear side of the page. Just like your yellow.
I stopped the print and checked image on the drum and transfer belt. Found it was not transferring developer from developer to drum.
My TCR levels were correct around 6 to 7.

What I found was the developer ! Just above the developer roller there is a black cover that goes the length of the developer roller. It slides in and clips into place. From a quick glance it looks in place but is loose and held in by tape if I recall. Not properly clipped in. When this guide is out of position it alters the developer to drum spacing causing faint prints front to rear.

I have attached a picture of a developer with a arrow pointing to the guide I am referring.

Hope this helps, if it the same as my issue I had.

regards

This is very interesting, thanks for heads up Mildred!

[joeywatt]

Re: C250i No yellow on rear side of page

I think you should check the patches. That worked for me too. safety pool fencepool fence