failed to memory overwrite

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • moonwalker3778
    Technician

    50+ Posts
    • Jun 2008
    • 87

    #1

    failed to memory overwrite

    Dear all,

    I am facing this prob at the start up screen of bizhub 350.machine displays only "failed to overwrite memory".



    any solutions pls.........

    thanks & regards

    Sudhakar naidu
  • ni311
    Senior Tech

    Site Contributor
    500+ Posts
    • May 2008
    • 658

    #2
    Did you try to reset it? A memory clear or something?
    Konica Minolta Error Codes - Explanations and Solutions

    Comment

    • jprecht
      Trusted Tech

      100+ Posts
      • Dec 2008
      • 104

      #3
      mem overwrite

      Inside front door on right remove cover to axcess service pcb short two init pins cheat front door and power up while depressing service reset sw on same board hold for 10 sec or so should reboot screen will say "initialization complete" try this first
      good luck jprecht
      IT IS BETTER TO REMAIN QUIET AND BE THOUGHT A FOOL
      THAN TO SPEAK AND REMOVE ALL DOUBT

      Comment

      • moonwalker3778
        Technician

        50+ Posts
        • Jun 2008
        • 87

        #4
        hi,

        sorry the message is " failed to overwrite all data".


        i ll tell the brief history.machine was sold by us warranty also over.customer tried to give amc to a third party for the goose.but nobody aware that service password was already set to this machine.finally third party failed customer came back to us with this prob.

        Comment

        • moonwalker3778
          Technician

          50+ Posts
          • Jun 2008
          • 87

          #5
          ya i solved the prob its a firmware issue.

          Thanks guys for ur support.

          Comment

          Working...