Bizhub 500(b&W)

[tecaldryn]

Re: Bizhub 500(b&W)

dear friends, thank you for answers.
actually this code is widely spoken here, but I think that is not giving an opportunity to solve it.
went to other places, ask technical and other assistance nemhuma happiness. I am thinking of changing the power supply, I noticed that the engine did not have a pulse machine to spin and connect with older, if I boot up and take the garaf, it works briefly, otherwise it already comes with code

Good stuff guys, just couple other things to look for. Take a good look at your toner bottle and make sure it doesn't have any burs on the ends, when customer tries to jam the bottle in the machine they could sometimes ruin the bottle. I've had it that after cleaning and testing loads I'll see the toner bottle hesitate while in rotation and the bottle was the problem, I've also seen those bottles with a severe warp; roll it on a table like a pool stick.

I've had good luck going in with the long thin vacuum adapter from the front door and sucking up all the spilled toner really getting in good at the cup and surrounding area. It takes 5 minutes and if it doesn't work, then rip the machine apart.

[pepper38_cnd]

Re: Bizhub 500(b&W)

There has been lots of opportunity to solve this. Install the new style upper Hopper ( it has a seal on the lower half to keep toner from leaking), New style bottle collar ( with the notch and the white mark ),the new style sensor holder, leave the rear screws out of the plate so any future service can be done from the front, install new sensor, clean completely and instruct your customers to not pull toner in and out and always line up the white line up before inserting new toner bottle. Problem solved !!!

I doubt the power supply has anything to do with it.