If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am looking for service manuals and some help for a Di5500. We are an all volunteer non-profit organization [ www.partners-international.org ] that received a Di550 (used) as a donation. We need the service manual because it seems we cannot set it up without going into the administrator mode and they did not give us the administrator pass code.
We have it making copies (with a small glitch that the first page seems to always jam) but the computer we have it connected to running windows 7 does not see it (even though the Minolta site says the WIN 7 64-bit driver is included in WIN 7)
We also need to re-set the program codes someone programmed into it for access to use the copier and for that we need the procedures and the to reset the administrator's access.
Ya know, I think I'm going to start a new post saying I have a service manual available for X. Then when the thread get's flooded with people posting there email address the spam will a come.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Thank you for the manuals. They were a great help. With them we were able to get in and get it running. Only 1 problem remains we could not find a solution for in the manuals.
We are running windows 7 Pro 64-bit. Even though we have green lights on the IO board in the copier and the router, Windows 7 does not see the copier so we cannot access it. I attached what the printer prints out. Seems like it does not have a good TCP/IP address, but we cannot find where to change it in the manuals. The machine did not come with a disk or any software, but the Minolta site says Windows 7 should already have a driver in it.... Any suggestions?
search for a file called x64_nonbizhub, at the minolta support site. This has the files to run 64 bit. If you cannot find it let me know your email and I will look at sending it to you.
It did not come up either on the main site or the drivers site. I did find PageScope and am trying to install that now, but nothing comes up for x64_nonbizhub
Comment