KM Bizhub C6500 Error code C0213

[swaggen]

Re: KM Bizhub C6500 Error code C0213

Synthohol, you are a master of your trade. Duplex produced copies. What direction should I head?

Cancel that. Same error on duplex after a few prints.

[Synthohol]

Re: KM Bizhub C6500 Error code C0213

I would still clean the one way gear and scuff the shafts as mentioned earlier.
Yes it's a pain taking off the finisher but that one way gear is timed somehow and you want it to turn as soon as the motor kicks in.
Usually a 15 minute fix. That little frame piece needs to come off to expose the gear. You will see what I mean.
If it was fuser related duplex wouldn't work at all. You managed to get some out.
Please try the suggestion and let me know.

[swaggen]

Re: KM Bizhub C6500 Error code C0213

I would still clean the one way gear and scuff the shafts as mentioned earlier.
Yes it's a pain taking off the finisher but that one way gear is timed somehow and you want it to turn as soon as the motor kicks in.
Usually a 15 minute fix. That little frame piece needs to come off to expose the gear. You will see what I mean.
If it was fuser related duplex wouldn't work at all. You managed to get some out.
Please try the suggestion and let me know.

Did the above, nope. They where clean a whistle and not binding to start with. The one way gear is the cam correct?

[Synthohol]

Re: KM Bizhub C6500 Error code C0213

drives the cam, yes.
try updating the firmware yet?