Minolta Konica C-5500 or IKON CCP-500

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • atechman
    Technician
    • Feb 2010
    • 13
    #1

    Minolta Konica C-5500 or IKON CCP-500

    I replaced yellow developer and SC-45-20 popped up. Fuser is fireing and machine cycle a min then code pops up. Any ideas anyone. Thank you
    Tags: 500, 550, 5500, code, color, cycle, developer, dirty, error, fuser, ikon, konica, minolta, pull, ratio, registration, replaced, rotated, unit, wrong, yellow
    • RRodgers
      Service Manager

      1,000+ Posts
      • Jun 2009
      • 1947
      #2
      Pull out your Yellow Dev unit and make sure it's ok. A 45-20 is a color registration error) I'd be willing to bet your yellow is not working right for some reason.
      Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

        Comment

        • atechman
          Technician
          • Feb 2010
          • 13
          #3
          Hello Rodger,
          Rodger that. I made a visual inpection 4 times and rotated he DV unit to make sure here were no binds or unusual abnormalities. The yellow being on top is riding in a drum with a 1/8'' rotational wear mark down to the alluminum. Could the drum charge leak effect this code. I also noticed a piazo type sensor towards the front of the Developer magazine well was dirty. I had brushed and vacuumed this sensor as well. The Dv unit is sitting as the remaining unit and plugged in. I thank you for leading me in the right direction but i am not sure what could have gone wrong in the DV change. Ig you have any other ideas,
          please let me know. Once again, I thank youfor your time.
          Respectfully, Doran

            Comment

            Previous template Next
            Working...