If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Konica C253 (Olivetti MF250) Dropping Black Developer - See sample attached
It's the K IU , had same issue just the other day - K IU started doing same as yours after bout 500 prints , replaced with new and it's been fine since
Don't expect the unexpected...............It ruins the surprise !!!!
It's the K IU , had same issue just the other day - K IU started doing same as yours after bout 500 prints , replaced with new and it's been fine since
Yes you could replace the imaging unit, but that fix is certainly a lot more expensive than the fix above!
hi did you sort out that problem.if so please assist me with the solution
thanks
As far as I know, the call has not come back in so I assume it is still working. I just followed the details from Pajeroid at the top of this thread! (look at the picture)
Don't expect the unexpected...............It ruins the surprise !!!!
Comment