If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Code has been intermittent. I have changed the PCU board/ADU board,paper feed motor and flashed firmware.Checked grounding spring and replaced TX unit door (with new spring). Any suggestions or possibilities? TIA
I replaced the PF unit in tray 2 because the screw holding it down in the back was broken. The code has not come back in 2 weeks. Keeping fingers crossed.
Bizhub600 C5005
Comment