banner printing on c5501

[primozks]

I'm trying to print banner 330x700 mm on c5501, but it only allows one paper in bypass tray. If more than one is loaded, paper jam occurs. Am I missing some setting, which would enable to load multiple papers to bypass tray?
Single paper loading works fine, but... It takes a lot of time to make several prints.
Thanks,
Primoz

[twinax]

Re: banner printing on c5501

Hi,

You need to validate this fonction.

It is necessary to change the DIP Switch 10-0 = 1 in service mode.

Regards,

Twinax

[drodas78]

Re: banner printing on c5501

I'm trying to print banner 330x700 mm on c5501, but it only allows one paper in bypass tray. If more than one is loaded, paper jam occurs. Am I missing some setting, which would enable to load multiple papers to bypass tray?
Single paper loading works fine, but... It takes a lot of time to make several prints.
Thanks,
Primoz

Hi, I want to print banner in C5501 with IC-408 fiery. Could you give me detailed explanation to do that?

Thank you.

[primozks]

Re: banner printing on c5501

Hi, I want to print banner in C5501 with IC-408 fiery. Could you give me detailed explanation to do that?

Thank you.

In my case all I have to do is define custom paper in print driver as 330 mm x 700 (or more) mm, usually 250 g, finishing face up in bypass tray. But as I remember, the serviceman enabled one option, that the banner can be printed. If it doesn't work with these setting, you have to call service to enable this option.

Primoz

[ni311]

Re: banner printing on c5501

Take a look on the link below, I believe it is what you need:

http://www.init-digital.ru/upload/files/manuals/Banner6500.pdf