DiAlta Di200 - network card problems

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • smart-refill
    Technician
    • Jan 2012
    • 27

    DiAlta Di200 - network card problems

    Hello

    I have a Di200 with Pi3502.

    Today I tried to print with my Di200 for the first time.

    The protocol address of Di200 is 10.233.21.108. Today I realized a short network with my PC and Di200. (the PC has 10.233.21.101 protocol address)

    When I tried to ping from my PC ping 10.233.21.108 errors returned. sometimes the ping was ok, but most of the times the ping retuned errors.

    I did not menage to print a test page.

    Can anybody help me?

    Thank you!
  • RRodgers
    Service Manager

    1,000+ Posts
    • Jun 2009
    • 1950

    #2
    Re: DiAlta Di200 - network card problems

    Originally posted by smart-refill
    Hello

    I have a Di200 with Pi3502.

    Today I tried to print with my Di200 for the first time.

    The protocol address of Di200 is 10.233.21.108. Today I realized a short network with my PC and Di200. (the PC has 10.233.21.101 protocol address)

    When I tried to ping from my PC ping 10.233.21.108 errors returned. sometimes the ping was ok, but most of the times the ping retuned errors.

    I did not menage to print a test page.

    Can anybody help me?

    Thank you!
    I believe those little PI's are little external fiery print controllers. Those are kinda known for the HDD's to go out on them after a couple/few years. Can you get to the network settings from the copier? Maybe try a ping 10.233.21.108 -t and let it run to see if it pings over a given time of about 3~5 mins. If it pings then stops then pings then stops it's the fiery stuck constantly rebooting and probably time for a new hard drive and OS reload.
    Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

    Comment

    • Hansoon
      Field Supervisor

      Site Contributor
      2,500+ Posts
      • Sep 2007
      • 3273

      #3
      Re: DiAlta Di200 - network card problems

      Bad news. Those NIC's go bad by aging. No replacement from the factory since years. About a million posts here in this forum about that issue.

      Hans
      " Sent from my Intel 80286 using MS-DOS 2.0 "

      Comment

      • smart-refill
        Technician
        • Jan 2012
        • 27

        #4
        Re: DiAlta Di200 - network card problems

        Thank you Hans!

        I will try to print using the parallel port.

        Best Regards!

        Sorin from Romania

        Comment

        Working...