transfer belt did not reset

[marlon29]

good day,

has anyone encountered that the newly installed transfer belt unit did not reset? The fuse was broken upon installing the transfer belt but the life did not reset.. C253 model, we tried to replace the unit with a new one but the life did not reset also...

any suggestions will do..

thanks



marlon

[JSC]

Re: transfer belt did not reset

Check for a blown ICP

[marlon29]

Re: transfer belt did not reset

we already replaced the board(prdb) because we found out that there is a blown icp(icp5) but still the problem is not corrected

[Osty]

Re: transfer belt did not reset

Are there any warning codes displayed during/after stabilization? Any P codes will prevent consumables from resetting.

[emujo]

Re: transfer belt did not reset

Check for 24v at the board..and perform continuity check from board through x-belt, back to bord.if not present, the MFP will not see the new fuse...if you can't repair this the CQ will start to drift off..EMujo

[sebastion]

Re: transfer belt did not reset

I would guess what the last guy said m/c may be showing a p-code got the oil can symbel ?

[blaze2000]

Re: transfer belt did not reset

Try doing a trouble reset? Flash firmware? As EMujo stated, check for 24 volts and continuity.

[Max Kilby]

Re: transfer belt did not reset

Had a similar issue with the Fuser reset on a C203. No oil cans. Transfer belt reset OK with our one though. Tried various things including soldering a quick blow really tiny fuse in circuit and it didn't blow either.

Ended up getting the 'new' firmware and reflashing the rom.

There is a firmware version that will allow you to turn off notifications for IU, Fuser and TB - though I don't know what the effect would be if you have already expired the life of your transfer belt.

MAX

[marlon29]

Re: transfer belt did not reset

we have found out that the lock of the transfer belt was grounded to main body that's why the transfer belt did not reset..

thanks alot