hi there im setting up a develop +220 i have gone through the set up process and went to do a copy and it came out with pink lines through it and sometimes blue does anyone no what i have done wrong or forgot to do ? many thanks dean
-
-
Re: blue and pink lines +220
Go through the setup procedure again, starting at the point where you plug in the machine. Don't skip any steps this time. There are 8 steps that must be completed in the correct sequence, for the calibration to be complete (no cyan or magenta lines).
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: blue and pink lines +220
Have you followed the setup procedure Thoroughly! If you have not a.e tried to do short cut or just missed date settings or etc it will do this until you do the set-up properly from A-Z.
If you did it properly then:
Does it happen when you print test page too?
How about copy from glass?Comment
-
Comment
-
Re: blue and pink lines +220
ok thanks i will go try that now
Comment
-
Re: blue and pink lines +220
yes went through set up again redone it all now its working fine thanks for your helpComment
-
Re: blue and pink lines +220
We call them the "lines of shame" after a dozen or so setups I say "who needs the instructions anymore" and of course every now and then, the "lines of shame"..For me it's usually the touch panel adjustment that I forget to do..EMujoIf you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.Comment
Comment