Jagged scan lines through ADF C352

[paulrid]

Hi all,

First off I hope this makes some sense.

When I print a lattice pattern all the lines are square and when I copy if off the glass they are also square but when I copy it through the ADF the vertical line about the 5th square down is jagged. Also the square 3 from the bottom is not straight. All the rest seem o.k. Any ideas?

Thanks in advance Paul.

[kingarthur]

Re: Jagged scan lines through ADF C352

Carry out the height adjustment on the RADF as per the manual...

[paulrid]

Re: Jagged scan lines through ADF C352

Carry out the height adjustment on the RADF as per the manual...

Thanks for the reply I'll give it ago.