kingarthur
Service Manager
Last Activity: 1 day ago
Joined: 02-24-2008
Location:
-
12 screws? - I only remove 3 , then you just remove the part that covers the 3 gears ... -
That's why I'm asking the bulletin says switch 187, but the manual says 189 - switch 187 is for something completely different, it's for image quality....Leave a comment:
-
Unfortunately I don't have the HEX for that switch, and it's been a while since I had to do binary ...Leave a comment:
-
Has anyone changed the software switch for the 5372 error, the "Read me" for the FW says
I was looking at the service...Leave a comment:
-
TBH, we don't appear to have many problems either, got about 250 devices, a mix of 8 series and iseries, can't remember the last time I had a "decent...Leave a comment:
-
Just an update, I went to the device a couple of days ago, and confirmed it was happening, I went into "level history 1" TCR K was at 3.65%,...Leave a comment:
-
I remember on a Sharp copier training course, many many moons ago, this subject was brought up in the classroom, the instructor said that copiers shouldn't...Leave a comment:
-
Yes, I had a couple of C454e that were driving me crazy, it just didn't make sense, even tried different DVs and DRs, used the wand to clean the glass,...Leave a comment:
-
remove and clean the PH unit, on these "earlier" models, quite often the copy/print was faded in one area, but on the internal prints everything...Leave a comment:
-
looking in the parts manual, there are only 2 gears listed with 23 teeth, A79J226200, is part of the drive assy and A64J719100 is in the 2nd transfer...Leave a comment:
-
Got a customer reporting this issue today, apparently it's appeared after changing the toner, we only use OEM. If they do more than one print, it's on...Leave a comment:
-
Me too - never had a solenoid fail...Leave a comment:
-
Yes, which is the annoying thing, no errors are usually displayed....Leave a comment:
-
Yep me too, until the got a rechargeable torch that's magnetic ...Leave a comment:
-
I find the quickest way to diagnose it, take out the DV unit, run your finger along the mag roller, so there's a clear patch, refit the unit, if the patch...Leave a comment:
-
You'd think so, but no noise, at least according to the customer, there isn't. I've probably had about a dozen, believe it or not, it's actually one of...Leave a comment:
-
What were the gears like on the DV unit you took out, quite often there's one gear that wears down, and the corresponding gear on the drive unit, also...Leave a comment:
-
It could mean that you don't have the OCR/LK installed - in which case, I could be leading you down the wrong path. Have a look to see if a licence is...Leave a comment:
-
Probably the easiest way, is go to scan. then select "scan type" then on the right you'll have PDF settings, if you have "OCR" installed,...Leave a comment:
-
The only time I've seen images rotate, is when the device has an LK105, or 110 with the OCR turned on, and the image set to Auto Rotate"...Leave a comment:
No activity results to display
Leave a comment: