If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
bizhub C452 - wide cyan strip (shadow) in sub-scan direction only in colour mode
bizhub C452 - wide cyan strip (shadow) in sub-scan direction only in colour mode
Hi at all,
each full-color copy or print-out have a wide cyan strip (shadow) in the sub-scanning direction. Black&white mode is okay. The examples in the attachment shows a black& white and a full-colour copy from the test chart. The other are half-tone printouts in cyan, yellow, magenta and black (density 70) from the tech. menu.
I removed the transfer-belt and checked it visually but no fault was found. After the re-install the stripes are much stronger than before.
It is a fairly new machine. Total count 9157
Can the transver-belt occur these stripes or I'm on the wrong way?
Leave a comment: