Hello, My c252 is shifting in the scan direction. Its fine when running prints or internal prints, it's only when you run anything through the ADF or on the glass. I noticed that the scanner was positioned about an inch past the document stop. I had suspected the image processor( the board that's under the lens) I brought the scan motor and home position sensor as well and installed. the scanner went back to it's normal position but when I ran a copy the same thing occurred. It scanning the proper length but starts scanning late so it goes past the page and scans the sky. Any suggestions? thanks
-
-
Re: Bizhub c252 cutting off
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Comment