Konica Bizhub C 253 C2152 Error Code

[Doug James]

Code won't clear, Took transfer belt out and it's working OK. Is their a common fix to this problem ?

[pepper38_cnd]

Re: Konica Bizhub C 253 C2152 Error Code

Try taking out the screw that holds the rear belt lock mechanism and replacing it with a screw 1/4 inch or shorter I have seen this screw come in contact with the gears (tranfer retracksion drive gears) behind the bracket if over tightened. Or if the wrong screw is put in after disassembly.

[JustManuals]

Re: Konica Bizhub C 253 C2152 Error Code

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Synaux]

Re: Konica Bizhub C 253 C2152 Error Code

"Relevant Parts:

Fusing motor (M5)
Transfer belt retraction clutch (CL7)
Transfer belt retraction sensor (PS31)

Printer control board (PRCB)"

[Doug James]

Re: Konica Bizhub C 253 C2152 Error Code

Thanks you guys... Really appreciate your help...

[Avskrap]

Re: Konica Bizhub C 253 C2152 Error Code

The standard fix for this is, if the belt is already factory modified per the technical notices, to tear the machine to pieces and replace the sensor mentioned by Synaux. It's located behind the main drum drive assembly. Replacing this sensor has solved the problem for me, every time.

[Darren King]

Re: Konica Bizhub C 253 C2152 Error Code

Avskrap is right. This isn't a 20 minute job though, so don't be in a hurry. The modified sensor assembly is available from KonMin.
Darren

[MFPTech]

Re: Konica Bizhub C 253 C2152 Error Code

Avskrap is right. This isn't a 20 minute job though, so don't be in a hurry. The modified sensor assembly is available from KonMin.
Darren

The sensor's position can be adjusted by using a long screw driver .... it will save lots of time

[173545]

Re: Konica Bizhub C 253 C2152 Error Code

Code won't clear, Took transfer belt out and it's working OK. Is their a common fix to this problem ?

I found this helpful.

[Doug James]

Re: Konica Bizhub C 253 C2152 Error Code

I found this helpful.

Wow... I am so grateful...

[Hansoon]

Re: Konica Bizhub C 253 C2152 Error Code

Try taking out the screw that holds the rear belt lock mechanism and replacing it with a screw 1/4 inch or shorter I have seen this screw come in contact with the gears (tranfer retracksion drive gears) behind the bracket if over tightened. Or if the wrong screw is put in after disassembly.

Great tip. Had this today with a BH-C-353 one of our techs was rebuilding. Thanks to you and this wonderful panel found the solution immediately here without loosing another hour to find it myself. The screw was obstructing the white lever behind the rear locking bracket of the transfer belt.

Thanks again for taking the time to post your solution!

Hans