Is it supposed to have holding brackets that fasten it to machine ??? It is made for them.... but do not have any on a recent machine set-up.
-
-
Re: PF-P08 Tray onto C35 Question
It should have them, but they are not necessary for machine to function....
Everyone has the right to be stupid. Some people just abuse this privelage more than others -
Re: PF-P08 Tray onto C35 Question
I found a installation sheet for the plain base we put on a C35 and it had brackets.Comment
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: PF-P08 Tray onto C35 Question
Thank you much, Instructions are vague at best. I always try to look the packing over closely. I modified a set from an old 350 to work. CWComment
Comment