sorry its the finisher i cant figure out how to remove
-
-
Re: bizhub c353 removal of fuser unit
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
-
Re: bizhub c353 removal of fuser unit
Maybe this help.Comment
-
Re: bizhub c353 removal of fuser unit
What model is the finisher? One of them has four screws that go through a plate on the finisher and fasten it to the left side of copier. The other one just has a bar that the finisher slides on and there is a long screw that goes through the bar to hold it.
They are both pretty easy to remove.Comment
-
Re: bizhub c353 removal of fuser unit
I highly advise to remove the transfer belt unit before removing the fusing unit. It can otherwise be damaged very easily in the process.
Hans“Sent from my Intel 80286 using MS-DOS 2.0”
Comment
-
Re: bizhub c353 removal of fuser unit
Yap and still you can hit the belt with the fuser unit if you don't take care.Why? The fuser clears the transfer belt by a wide margin.
Hans“Sent from my Intel 80286 using MS-DOS 2.0”
Comment
-
Re: bizhub c353 removal of fuser unit
You must be doing it with your eyes closed Hans.
Well, if you are in a hurry and if you have rheumatic pains in your hands and if the fusing unit is hot as molten lava and if you are suffering from a serious bout of dumbfuckness, than you might let the fusing unit slip out of your hands hitting the fuser belt causing a fat nick in it.
Ofcourse this all never happened to me. Ofcourse.
Hans“Sent from my Intel 80286 using MS-DOS 2.0”
Comment
Comment