Develop Ineo +220 (Konica) C220

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • CrapAimer
    Trusted Tech

    250+ Posts
    • Jan 2010
    • 296
    #1

    Develop Ineo +220 (Konica) C220

    Hi all

    Just wondering if anyone has come across this fault, The paper is going in squint when using tray 1 but works fine with tray 2 ?
    Tags: None
    • habik
      Service Manager

      Site Contributor
      1,000+ Posts
      • Apr 2010
      • 2013
      #2
      Re: Develop Ineo +220 (Konica) C220

      Check the vertical paper guide, they tend to pop out due to incorrect paper jam removal OR separation tyre is warrrped aor worn to one side, usually damaged by mylar on paper cassette RH side. i tend to trim them in 45 degree angle
      .OK Google! ... will I need Berrocca this morning?
      Firmwares HERE

        Comment

        • Copier Addict
          Aging Tech

          Site Contributor
          10,000+ Posts
          • Jul 2013
          • 14497
          #3
          Re: Develop Ineo +220 (Konica) C220

          Not sure what "going in squint" means, but, if you mean it is skewing, then you need to concentrate on the 1st tray and feed feed assembly. Make sure the guides are straight and against the paper. Check for any burrs or damaged mylars in the paper path. The feed assembly is easy to remove.
          Hope this helps
          Darren

            Comment

            Previous template Next
            Working...