Konica Minolta C 353 Fuser Roller Issue

[junidexy]

I have a issue, My Fuser Unit Fuser roller got Damaged, what might cause this problem, any body help me, image is attached in this

[Synaux]

Re: Konica Minolta C 353 Fuser Roller Issue

I have a issue, My Fuser Unit Fuser roller got Damaged, what might cause this problem, any body help me, image is attached in this

Ouch, there is an updated firmware for temp to help avoid damage to the fuser. Also, make sure sleep mode is enabled.

[JustManuals]

Re: Konica Minolta C 353 Fuser Roller Issue

I have this firmware, email me if interested in purchasing it.

Paul@justmanuals.com

[jotunn]

Re: Konica Minolta C 353 Fuser Roller Issue

Time makes this - this is known issue with machines or fusing units kept unused for a long time (year or so).

[methogod]

Re: Konica Minolta C 353 Fuser Roller Issue

all of the Konica business line is not made to be READY to use at all times. I would set it to SLEEP after 3 minutes, so that it powers off, they all warm up so fast, that cost of parts is not worth that few seconds it takes to wake up...

in fact some of the newer ones have motion sensors so when your walking up to it you can set it to make (C554 series)...


change fuser
set lowpower to 1 minute, sleep to 5 minutes.
or less...

should last longer...