bear pod switches for vendor mode 2

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • leoS6N
    #1

    [Misc] bear pod switches for vendor mode 2

    Does anyone know the swich configuration for the bear pods for vendor mode 2 on KM gear
    Tags: None
    • TheOwl
      Service Manager

      Site Contributor
      1,000+ Posts
      • Nov 2008
      • 1732
      #2
      Re: bear pod switches for vendor mode 2

      I don't know what all the switches do, but I do know that switch 3 cancels clicking for scanning.

      Otherwise, we have left all the ones we have installed in their factory position and have only every needed to change switch 3 for one machine only.
      Please don't ask me for firmware or service manuals as refusal often offends.

        Comment

        • Hansoon
          Field Supervisor

          Site Contributor
          2,500+ Posts
          • Sep 2007
          • 3350
          #3
          Re: bear pod switches for vendor mode 2

          WTH are "bear pod switches"?

          Hans
          “ Sent from my Intel 80286 using MS-DOS 2.0 “
          https://www.copytechnet.com/images/smilies/biggrin.png

            Comment

            • TheOwl
              Service Manager

              Site Contributor
              1,000+ Posts
              • Nov 2008
              • 1732
              #4
              Re: bear pod switches for vendor mode 2

              BEAR Solutions make a cost recovery system as well as terminals that interface to the copiers.

              The BEAR Pod is what they call the interface unit which interfaces the terminal to the MFD.
              Please don't ask me for firmware or service manuals as refusal often offends.

                Comment

                • Hansoon
                  Field Supervisor

                  Site Contributor
                  2,500+ Posts
                  • Sep 2007
                  • 3350
                  #5
                  Re: bear pod switches for vendor mode 2

                  Thanks Owl.

                  Hans
                  “ Sent from my Intel 80286 using MS-DOS 2.0 “
                  https://www.copytechnet.com/images/smilies/biggrin.png

                    Comment

                    • leoS6N
                      #6
                      Re: bear pod switches for vendor mode 2

                      Originally posted by TheOwl
                      BEAR Solutions make a cost recovery system as well as terminals that interface to the copiers.

                      The BEAR Pod is what they call the interface unit which interfaces the terminal to the MFD.
                      The bear pod is the device that communicates between the MFP and the "Coin box/ authentication device" inside there are 10 hard switches to set to your needs.

                      i found out that vendor mode 2 requires 7 & 10 to be set to on.

                      TheOwl was correct 3 is scan, 4 is fax and 5 is print

                        Comment

                        Previous template Next
                        Working...