C1060 pro banner printing

[bronzegixer]

Hi All
can someone tell me the engine Dip Sw so we can enable banner printing

[Mick01]

Re: C1060 pro banner printing

10-0 to on

[bronzegixer]

Re: C1060 pro banner printing

10-0 to on

Hi Mike

Yes thought it was same as on the old c5501 10 - 0 to 1 also 10-1 to 0

It worked ok with the finisher on but now we have put the RU 509 decurler /online denistometer on between the machine and finisher, it wont work go all the way through, stops just before it starts to come out the finisher, I think its maybe due to different speeds in the machine, any Ideas or will it be a case of pulling these 2 units off each time.

thanks k

[hotfuser]

Re: C1060 pro banner printing

10-0 to on

i have enclosed a document that KM have released regarding banner printing on the C1060.

i hope this helps.

[samanthaevans]

Re: C1060 pro banner printing

[Massy]

Re: C1060 pro banner printing

Hi Mike

Yes thought it was same as on the old c5501 10 - 0 to 1 also 10-1 to 0

It worked ok with the finisher on but now we have put the RU 509 decurler /online denistometer on between the machine and finisher, it wont work go all the way through, stops just before it starts to come out the finisher, I think its maybe due to different speeds in the machine, any Ideas or will it be a case of pulling these 2 units off each time.

thanks k

Hi Guys,

I know this is a bit of an old thread but can someone guide me on where to find the Dip Sw on the KM1060?

Many thanks.

[Synthohol]

Re: C1060 pro banner printing

0px; "> (2) Procedure
1. "Service Mode menu screen"
Press [03 System Setting].
2. "System Setting Menu screen"
Press [01 Software DIPSW Setting].
[Service Mode] → [System Setting] → [Software DIPSW Setting]
3. "Software switch setting mode screen"
Press [▲] / [▼] or numeric buttons after you press the "DIPSW number" and "Bit number" buttons.
4. Press [On (1)] or [Off (0)] to configure the selected bit number ON/OFF.

[Massy]

Re: C1060 pro banner printing

0px; "> (2) Procedure
1. "Service Mode menu screen"
Press [03 System Setting].
2. "System Setting Menu screen"
Press [01 Software DIPSW Setting].
[Service Mode] → [System Setting] → [Software DIPSW Setting]
3. "Software switch setting mode screen"
Press [▲] / [▼] or numeric buttons after you press the "DIPSW number" and "Bit number" buttons.
4. Press [On (1)] or [Off (0)] to configure the selected bit number ON/OFF.

Thanks for your help.

How do I get to "Service Mode" please?
Pardon my ignorance, I am new to KM machines. More familiar with Xerox's.

Does anyone have a service manual to share?

Many thanks.