Re: Bizhub 600 stumping me.
If you hadn't switched entire feed units, I would strongly suspect the regulating block oneway slipping. I would scuff up the shaft anyway and see if it helps. Konica says to tie it up with a zip-tie so that it don't move forward but I never need to do that.
Remove the bypass section and look for torn paper scraps at M1. Make sure loop sensor flag operating freely.
I work on a ton of these. I make absolute declarations very conservatively, it almost has to be one of those things.
If you hadn't switched entire feed units, I would strongly suspect the regulating block oneway slipping. I would scuff up the shaft anyway and see if it helps. Konica says to tie it up with a zip-tie so that it don't move forward but I never need to do that.
Remove the bypass section and look for torn paper scraps at M1. Make sure loop sensor flag operating freely.
I work on a ton of these. I make absolute declarations very conservatively, it almost has to be one of those things.
Comment