c650 Tray 3 & 4 constant jamming after accidental 110# ran from tray 3

[Synaux]

So, apparently some 110lbcover stock was mixed up in some 100lb Hammermill cover and it naturally jammed in the side hatch (below the bypass)

Changed pickup rollers (even ordered a few of the new roller mentioned in this thread

[Synaux]

Re: c650 Tray 3 & 4 constant jamming after accidental 110# ran from tray 3

Well I figured out that the latch was broken off on the side hatch (below the bypass) toward the read of the machine.

And obviously it was not the conveyance leveling section rollers as it was happening out of tray 4 too. Weird that it was random on tray 4 and always jamming on tray 3.

I know no one posted on this particular thread, but thanks to other advise on this forum, I looked closer at that (errant) latch.

Thanks!