kyocera jam 4602 , the copies goes wrong way

[cdvidaceiba]

hi i got a Kyocera 8000i thats works fine for the right tray , but if i want to use the left trays the copies jams in the exit section , specificaly the copies goes for the duplex not for the exit ... i already tried everything

thanks in advance for the help

[ntbann]

Re: kyocera jam 4602 , the copies goes wrong way

Check the transport sensor flags. They get wore off and cause the jam you listed.

[cdvidaceiba]

Re: kyocera jam 4602 , the copies goes wrong way

i suspect of the duplex flapper (guide change lower 302K928213) seems worn out , i dont have one for replacement i will try to modify this one

i check the sensors but the machinne works fine if you program a copy duplex mode and right exit , the problem is only when you program left exit the copy doesnt go for the exit to the bridge unit , the copy goes for the duplex

[cdvidaceiba]

Re: kyocera jam 4602 , the copies goes wrong way

i solve the problem modified the whole unit , i had to displace the exit unit to the rear , the machinee work ok now