Which Kon.Min. feed rollers are preferred to use in 4550ci ?

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • JR2ALTA
    Service Manager

    Site Contributor
    1,000+ Posts
    • Feb 2010
    • 2033
    #16
    Re: Which Kon.Min. feed rollers are preferred to use in 4550ci ?

    These gadgets! I don't get it. Push the hub up through the rubber the roller wiggles off pretty darn easily.

      Comment

      • subaro
        Service Manager

        1,000+ Posts
        • Oct 2010
        • 1274
        #17
        Re: Which Kon.Min. feed rollers are preferred to use in 4550ci ?

        Originally posted by JR2ALTA
        These gadgets! I don't get it. Push the hub up through the rubber the roller wiggles off pretty darn easily.

        Obviously you have not worked with the neoprene rollers, they are not elastic like the rubber rollers and getting them off and on the hub is not an easy task, if you are going to keep the roller and hub intact. Neoprene rollers are not like rubber rollers, very different materials.
        THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burke

          Comment

          • JR2ALTA
            Service Manager

            Site Contributor
            1,000+ Posts
            • Feb 2010
            • 2033
            #18
            Re: Which Kon.Min. feed rollers are preferred to use in 4550ci ?

            Originally posted by subaro
            Obviously you have not worked with the neoprene rollers, they are not elastic like the rubber rollers and getting them off and on the hub is not an easy task, if you are going to keep the roller and hub intact. Neoprene rollers are not like rubber rollers, very different materials.
            Konica Minolta A00J563600? I've done hundreds. If anything the different material makes it easier to get off. But that's just my opinion.

              Comment

              • subaro
                Service Manager

                1,000+ Posts
                • Oct 2010
                • 1274
                #19
                Re: Which Kon.Min. feed rollers are preferred to use in 4550ci ?

                Originally posted by JR2ALTA
                Konica Minolta A00J563600? I've done hundreds. If anything the different material makes it easier to get off. But that's just my opinion.

                I have never removed the rollers you mentioned or any of the other guys mentioned above. I don't really work on konica as such. If you read my entire post on this thread i was referring to the kyocera rollers on the pf-750 console. I can give you now untill christmas and you will never remove those with hand strength. Other neoprene roller i see are sometimes easier, but nevertheless difficult to wiggle out the drum.

                20160828_192820.jpg

                see the thickness on the roller above, that thing does not move one iota, you can get nothing between that roller and hub and you cannot push with hand strength. only some mechanical or hydraulic device will move that roller out of that hub.
                THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burke

                  Comment

                  Previous 1 2 template Next
                  Working...