TA221 J11

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • blackdog
    Trusted Tech

    100+ Posts
    • Jun 2012
    • 211
    #1

    TA221 J11

    Hey you Kyocera Aces,
    Got a TA221 giving a J11 Jam code from cassette 1.
    I installed new feed/sep rollers, clutch is working fine.
    Swapped out cassettes and still N/G.
    What bugs me is sep roller is turning but no feed?
    Any suggestions would be greatly appreciated.
    Tags: None
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      Re: TA221 J11

      Is the separation roller flopping around because, maybe, the plastic post that it swivels on is busted off? =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • blackdog
          Trusted Tech

          100+ Posts
          • Jun 2012
          • 211
          #3
          Re: TA221 J11

          Originally posted by blackcat4866
          Is the separation roller flopping around because, maybe, the plastic post that it swivels on is busted off? =^..^=
          Hey thanks Blackcat for your reply. Hope all is well on your end.
          I replaced sep and feed rollers this morning and all corresponding parts looked to be intact.
          If I could take a stab it I would say Feeder roller is not coming in contact with paper?
          I would assume the clutch is turning the shaft and all rollers than paper should feed?
          Is feeder roller stationary or does it drop down to meet paper at some time?
          I don't see any signs of feeder roller coming in contact and moving paper at all.

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 22973
              #4
              Re: TA221 J11

              Originally posted by blackdog
              Is feeder roller stationary or does it drop down to meet paper at some time?
              I don't see any signs of feeder roller coming in contact and moving paper at all.
              The pickup roller is spring loaded, but it's the spring loaded lift plate that lifts the paper up to the the roller. It's generally a pretty crappy feed system. IIRC the spring clutches will wrap if a paper jam isn't removed correctly. If you remove the rear cover, you can make a Sharpie mark on the end of the feed shaft, then watch to see if it rotates. My bet is that it isn't, and you need a clutch. =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                Previous template Next
                Working...