hello I have a kyocera km2560 copier that will only print about 4 inches of the top of the page did a full maintenance and still same problem any one have any suggestions
Thank you
Thank you
-
-
If you phrase your inquiry properly, you will get the answers you seek...
Good Luck ... You'll need it! HAHAHA!
~Big Dan~
-
Re: kyocera KM2560 prints 4 inches top of page
I'm thinking that you did not run simulation U130, so the developing unit is filling verrrrry slllooooowwwly with the monocomponent toner. There is a simulation sheet in that maintenance kit that would have told you to do this.
Just a hint: If you want an opinion on a quality issue, maybe you should include an image? =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: kyocera KM2560 prints 4 inches top of page
Hi I tried the u130 it got a little better have about 10 inches now from the topComment
-
Re: kyocera KM2560 prints 4 inches top of page
That particular image sample doesn't tell me very much. try this:If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment