Kyocera 5050

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Brischaffer
    Technician

    50+ Posts
    • Oct 2008
    • 68
    #1

    Kyocera 5050

    I have a KM-5050 thats giving me intermiten blind jams with a Jam code of 81. The book tells me its and entry sensor in the finisher. I have them on order. The finisher is the PF-730. Just wondering if anyone has seen this before.

    Thanks

    Brian
    Tags: 5050, comming, km 5050, kyocera
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      I'm just passing along what I've heard. My Falcon IIIs seem to be running OK.

      According to a reliable source the main problem seems to be in the AK-700, at the gate. Replace the AK-700. Also, try reducing the fuser temperature to reduce paper curl. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • fitsy.13
          senior tech
          50+ Posts
          • Feb 2009
          • 64
          #3
          Originally posted by Brischaffer
          I have a KM-5050 thats giving me intermiten blind jams with a Jam code of 81. The book tells me its and entry sensor in the finisher. I have them on order. The finisher is the PF-730. Just wondering if anyone has seen this before.

          Thanks

          Brian
          hi i had quiet a few of these models out with the jamming in to the finisher i ended up changing the ak700 km did do a slight mod on them i also fit these to the older models to

            Comment

            • techman
              Technician
              • Dec 2007
              • 49
              #4
              have had this same problem a few times and Ak 700 has worked but did have one that came from the exit assy. solenoid not acuating properlly but that problem was comming from duplex and faxes only or when inverting to the finisher

                Comment

                • Brischaffer
                  Technician

                  50+ Posts
                  • Oct 2008
                  • 68
                  #5
                  KM 5050

                  Thank you for all the imput you all have given me. I replaced the AK-700, Sensors, Finisher main board and the problem was still there. I thing that fixed was the most recent firmware(go figure). It was ver. 2.20D. So far so good. Thanks again for all the help.

                  Brian S

                    Comment

                    Previous template Next
                    Working...