KM-3060 setup???

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • cmpelser
    Trusted Tech
    • Jan 2008
    • 173
    #1

    KM-3060 setup???

    Ok, so i've installed this KM-3060 a few weeks ago.
    everything is fine, but the I.T guy wants it setup in a certain way...
    They have about 50 to 60 users.
    He has setup job accounting for all the users, and everyone has a docbox.
    The problem is that when a user comes to the machine, he has to put in his pin code (job accounting) ... all fine.
    Then the user presses docbox and has to scroll through ALL 50 TO 60 BOXES to get there prints!!!

    Is there a solution to this?
    he wants the user to go to the machine, pin number, then just THAT user's docbox shows up.
    anyone???
    Tags: acct, job accounting, km3060, pin code, release, setup
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22999
      #2
      Unless it shows up in some future firmware release, nothing like that exists now. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • kyoceradude
          The Great Gazoo

          250+ Posts
          • Aug 2006
          • 442
          #3
          We have a school dist with over 40 Falcon 3's and 6030's that use over 425 job acct/box codes. Imagine scrolling thru that list. Oh by the way, they have also programmed e-mail addresses. It's a lot quicker just entering the info manually each time.
          My mission here on Earth is to help all you Dum-Dums!

            Comment

            Previous template Next
            Working...