Hi all,
Have a km2550 in the field that has been causing me problems almost since installation.The main problem at the moment is jamming in the fuser. Now the customer prints off a daily newsletter with quite a lot of toner coverage(adverts etc) that causes over a short space of time,toner to build up on the paper side of the pick-off/seperator claws causing jams.Replacement or cleaning will sort the problem for a while.Also installed a cassette heater for paper issues and lightned the print density and dev bias.Should I make fuser adjustments,we have also had to replace the heatroller a couple of times even though the unit has only 150k on it.Is it me or are these models a disimprovement on the previous km model?? Thanks for any info.....
Have a km2550 in the field that has been causing me problems almost since installation.The main problem at the moment is jamming in the fuser. Now the customer prints off a daily newsletter with quite a lot of toner coverage(adverts etc) that causes over a short space of time,toner to build up on the paper side of the pick-off/seperator claws causing jams.Replacement or cleaning will sort the problem for a while.Also installed a cassette heater for paper issues and lightned the print density and dev bias.Should I make fuser adjustments,we have also had to replace the heatroller a couple of times even though the unit has only 150k on it.Is it me or are these models a disimprovement on the previous km model?? Thanks for any info.....
Comment