I got a km8030 that has one of the two tabs broken off that contact the dev unit
does anyone have a part number for this? not in parts manuel
does anyone have a part number for this? not in parts manuel
-
-
It's not in the KM8030 manual or the KM820 manual. I've looked myself. I'll check the bulletins tomorrow. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Not sure what you are referring to but this may help.Comment
-
Thanks Hose1cook, than exactly what's needed.
bsm2, the rear frame (item #1) has the developing bias contact that you're looking for. I've got a few worn ones, just not yet at a crisis stage. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
update Kyocera has just the clip part#302FB08481 terminal DLP roller
part design change new styleComment
-
Even better. Thanks! =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment