Taskalfa300/400ci

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • lazer
    • May 2025
    #1

    Taskalfa300/400ci

    hi all,

    taskalfa300/400ci series displays TIME for MAINTANANCE (T)
    MFP has just done 60k prints
    i have reseted all the maintanance count and even upgraded the latest firmware

    PLS HELP

    regards
    Tags: 400ci, calibration, count, displays, email, est, even, half, halftone, hi all, internet, main, manual, manuals, one, parts, series, service, service manual, simulation, taskalfa, time, upgraded
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      What do you see in simulation U251? =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • JustManuals
          Field Supervisor

          5,000+ Posts
          • Jan 2006
          • 9838
          #3
          This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


          Paul@justmanuals.com

            Comment

            • lazer
              #4
              i have cleared all the maintainance counts

                Comment

                • Vandys
                  #5
                  This is the call to do "Halftone calibration".

                    Comment

                    Previous template Next
                    Working...