KM8030 opimizing performance

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Mr Bean
    • Jul 2025
    #1

    KM8030 opimizing performance

    Hi EVERYBODY,
    I have a problem witg Kyocera Mita KM 8030. After making a copy or a set of copies, the machine stop and indicate that the machine is optimizing performance and nothing can be done until turning power switch off and on again.then the condition repeated again. please help me !! give me solution !
    Tags: amou, copies, copyi, front cover, km 8030, kmc3232, kyocera, kyocera mita, mita, power, solution, switch
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 23008
      #2
      I'd start by reloading the firmware. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • kmteck
          Technician
          • Dec 2009
          • 37
          #3
          Check the air filters in Front cover and all other vents. This is caused by not cleaning or replacing the mentioned filters.
          Good Luck...

            Comment

            • just a tech
              Service Manager

              250+ Posts
              • Jan 2007
              • 332
              #4
              When you see "optimizing performance", the machine is going through a cool down cycle and will return to ready after the machine's internal temperature reaches an acceptable amount (usually appears after a large amount of copying). Sometimes I have seen it take as long as 5-10 minutes for the message to clear but if you turn it off before it finishes it's cool down cycle, most of the time the machine immediately shows the message again on display. As mentioned, make sure your filters are clean. I'd also check to ensure your exhaust fans are operational (especially those near fuser area), fuser thermistors clean and in proper position, and ensure machine has proper clearance around the cabinet so it can breath properly. You do those 4 things and you should be just fine...Good Luck..

                Comment

                Previous template Next
                Working...