Kyocera KM 3060 can't connect to network now changed network card settings

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • goose1127
    • Jun 2025
    #1

    [Misc] Kyocera KM 3060 can't connect to network now changed network card settings

    I was in the command center on a Kyocera 3060 and inadvertntly changed the 10/100 auto connections from auto to 10baseTfull now I can't get in to the printer through the web command cernter to change it back and can't find that setting in the control panel on the printer. anyone know where to find that?
    Thanks
    Tags: command center, connections, control, kmc3232, kyocera, network, panel, printer, set, setting, web, work
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22999
      #2
      An engine reset should do the trick. Send this PreScribe command:

      !R! EGRE;EXIT;
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • goose1127
          #3
          I found the answer I used the 1087 and 021 command and reinitiated the memory. That set it back to factory defaults andit's great now.
          Thanks for the reply...

            Comment

            Previous template Next
            Working...